Garage door won't close: sensor repair in Westfield

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (908) 402-7176

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Westfield repairs the sensors and re-tests the opener's safety system.

Ceiling opener and torsion spring over a single garage door

Doors that won't close in Westfield

Westfield's older neighborhoods, Stoneleigh Park, Kimball Avenue and the Gardens, have detached garages at the end of long narrow driveways, built decades before openers. Sensors there are mounted on old wood jambs and get little attention. In Wychwood and Indian Forest, attached garages are tight for modern SUVs, and brackets are bent by bumpers. In Brightwood and Manor Park, compact post-war garages double as storage. With mature street trees across town, leaves pile against garage doors in November, and a door that reverses at the last inch is usually reacting to them.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Westfield

  • Stoneleigh Park: About 30 houses on 20 acres from 1904, with large period homes.
  • Indian Forest: North-side estate neighborhood with large lots and mature trees.

See the full Westfield service area.

Garage door won't budge? Call first, force it never.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (908) 402-7176
Call (908) 402-7176